|

Plug In with Analog Inputs (2) and Outputs
(6) (3.5mm jacks)
Coaxial Digital Input/Output and Optical Output for Pure
Digital Audio Transfer
High-Fidelity Headphone Amp, Microphone Pre-Amp and Headset
Jack
Independent Surround Sound Channel Volume Control
Support Game Surround Sound API's such as EAX 2.0 and A3D
*FYI, AUDIOTRAK MAYA EX (with RCA jack) is continued to be
produced.
Shipping Available from 12th November, 2003
Windows' default driver & MAYA EX5's exclusive Sensaura
3D driver
MAYA EX5 can use 2 alternative drivers. These are
a Windows default driver and an exclusive Sensaura 3D driver.
From the very
beginning, MAYA EX5 has a SENSAURA 3D 2003 algorithm, so it
can accelerate a sound source faster with DirectSound 2D,
Direct Sound 3D, API, A3D 1.0, EAX 1.0, EAX 2.0, MacroFX,
EnvironmentFX, or MultiDrive. You may appreciate a perfect 3D
sound source. This does mean the as same as the gaming sound of the PCI based
cards, all sound sources can be
accelerated. There is no acceleration engine in current USB
devices, so Maya EX5 is the innovative USB device which is
equipped with Sensaura 3D. Also, EX5 uses a HAL mode to access
a sound file, so CPU usage rate is lower and it makes
3D-game possible to access easily. Most kinds of PC (Desktop,
Notebook, slim, etc) can be adjustable for use with Maya EX5.
Independent 5.1 volume control and output
MAYA EX5 has an independent 5.1 volume controller for each
speaker and woofer, if you have the multi-channel software (PowerDVD,
WinDVD, etc), you may appreciate the audio sources (Dolby
digital, AC3, DTS, Dolby ProLogic 2, etc) without any decoder.
DiVX, AC3/DTS file and WMA 5.1 is also possible to play in 5.1
channel.
Special equipment: Headphone AMP(60mW @32 ¥Ø)
MAYA EX5 has High-fidelity headphone and is equipped with the
Headphone driver of Phillip's TDA1308 (60mW
X2(320hm~1500hm), therefore, you can appreciate high quality
sound. And, you don't need to take off speaker wire and
slot into headphone jack like the current sound card. You can
slot directly in headphone because it is designed by using
alternative equipped jack (Headphone and Optical out).
Optical & Coaxial input/output for S/PDIF.
Since MAYA EX5 has Optical & Coaxial input/output for S/PDIF,
much more application is adjusted as perfect digital sounding
work station. This system is very compatible to connect a
decoder, receiver. MD, DAT, Digital Amp, etc..
| MAYA EX5 Specifications
Interface: FULL SPEED USB (USB
1.1 COMPATIBLE)
Analog Inputs
Type: 2 Channel Analog line inputs (3.5mm Jack)
Level: -10dBV Unbalanced, -10dBV Nominal, +6dBV Maximum
Impedance: 10K Ohm
Analog Outputs
Type: 6 Channel Analog line outputs(3.5mm Jack)
Level: -10dBV Unbalanced, -10dBV Nominal, +0dBV Maximum
Impedance: 100 Ohm
MIC Preamplifier
Gain: +40dB Fix
Impedance: 10K ohm
Headphone Output
Type: 3.5mm Mini Phone Jack
Output Power: 60mW Max
Signal to Noise Ratio: 110dB (Typical)
(THD+N)/S: -70dB, 0.03% (Typical)
Support Headset Connector (3.5 mm Jack)
Sample rate supports: 48 kHz
Bits Resolution: 16-bit
Digital I/O
Type: Coaxial input & Output Connector
Type: Mini Optical Output Connector (TOS- LINk)
Format: IEC-958 Consumer (S/PDIF)
Sampling Rate: 48 kHz
Bit Resolution: 16 bit
A/D Converter
Dynamic Range(S/N): 91 dB A-Weighted (Typical)
Frequency Response: 20 ~ 20KHz
Resolution: 18 Bit
D/A Converter
Dynamic Range (S/N): 88 dB A-Weighted (Typical)
Frequency Response: 20 ~
20KHz (@ fs=48kHz)
Resolution: 18 Bit
For
more details vist Audiotrack
|
Source: Audiotrak |